CEL Power8 workshop Bedienungsanleitung PDF herunterladen (Seite 62)

11. Drill Press

Store the Table Saw Properly

WARNING. Always ensure that the saw is

switched off and the POWERhandle is detached

from the tool before disassemble the product

from the case.

General Inspection

Regularly check that all the fixing screws are

tight. They may vibrate loose over time.

1. Open Case lid, slide the internal plug away

from the Jigsaw.

2. Put internal plug back to its storage area.

3. Slide back the product lock, and remove the

Circular Saw Head from the bottom of the lid.

4. Replace the tools to the Lift Out Tray before

putting them back into the Case for storage.

NOTE: The Lift Out Tray is for easy storage and

protection of tools inside the Case.

5. Disconnect the product from the mains power.

Bevel Cut

1. Open the lid of the saw table, adjust the

circular saw bevel angle by releasing the lock

knob and re-tightening at the desired angle.

2. Position the fence at the desired distance

from the blade.

3. Use the provided push stick or a push block to

move the workpiece through the cut and past the

blade.

WARNING: Never push a small piece of wood

into the blade with your hand, always use the

provided push stick or a push block.

Table Saw-Maintenance

10.5

Table Saw - Operating Instructions

10.4

Bevel Cut

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 85 86

Keine Kommentare

CEL Power8 workshop Bedienungsanleitung Seite 62