CEL Power8 workshop Bedienungsanleitung PDF herunterladen (Seite 68)

Store the Drill Pres Properly

WARNING. Always ensure that the drill press is

switched off and the POWERhandle is removed

from the charger dock before disassembling the

product.

1. Remove the post lever from side of the post.

2. Release the chuck and remove ant cutting

tool.

3. Pull the green product lock backward and

with the other hand slide the drill head down and

out of the posts mating faces.

4. Lift the green post Release Lever up to

release the post from the case.

5. Slide the post out from the case hole.

6. Open the lid of the case, replace the tools into

the lift out tray and putting them back into the

case for storage.

NOTE: The Lift Out Tray is for easy storage and

protection of tools inside the Case.

7. Return the post into its storage area on the

back of the case.

8. Disconnect the product from the mains power

and return the SCP to its storage area.

General Inspection

Regularly check that all the fixing screws are

tight, they may vibrate loose over time. Ensure

that all vents are clear of dust, swarf and debus.

12. Scroll Saw

Drill Press - Maintenance

11.5

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 85 86

Keine Kommentare

CEL Power8 workshop Bedienungsanleitung Seite 68